ROTOCALCO COMEXI R2

MATERIALS TO WORK PLASTIC FILMS PET 12µ - 40 µ BOPP 15µ - 50 µ OPA 12µ - 60 µ PAPER 40 - 120gsm COUPLED 50 - 150 µ The materials must be first choice market standards. Shots need to be adjusted depending on the thickness and light of the materials. Performance Reference print: OPA 12 microns Solvent-based printing with ethyl acetate Maximum coverage 200% Maximum speed 200 m/1' Drying temperature: 55°c Solvent retention less than 10 mg/m2 Registration tolerance: +/- 0.1mm Pitch tolerance: 0.2% (2 mm on 1 meter) TECHNICAL INFORMATION Maximum belt width: 1,050 mm Maximum printing width: (with line and marks) 1,030 mm Maximum printing cylinder table: 1,100 mm Mechanical speed: 350 m/min. (The working speed is influenced by the type of tools inks and solvents used, the opacity values of the print, the depth of engraving and the finish of the engraved cylinders, the type of material to be machined and the capacity of the operators). See also guaranteed performance specifications. Number of printing elements: 6 Print development: Minimum: 450 mm Maximum: 920mm Electric energy The customer must provide the following lines: Power connection (400V / 50 Hz +/-10% three-phase without neutral and with conductor earth) between the cabin and the main machine switch Separate 220 Volt connection for cabinet and machine lighting Separate 220 V power supply for the solvent concentration control system (LEL). The connection points are indicated in the general machine diagram Installed electrical power: 231 kW (preliminary data to be confirmed) Electrical power used: 109 kW (preliminary data to be confirmed) Thermal power required With all chambers functioning and for maximum temperatures 100°C/140°C and minimum recirculation 50%: 512,000 Kcal/h Actual consumption depends on the temperatures and recirculation % set. Heating type: OIL Diathermic oil requirements: Chamber 1.8m: oil temperature at the inlet flange Tin 230°C, 6700 l/min x 5 (50-100% recirculation) Chamber 4.5m: oil temperature at the inlet flange oil temperature at inlet flange 230°C - Tout 205°C, 10720 l/min x 2 (0-100% recirculation) Belt cooling circuit Supply with water at a temperature < 20 °C Exhaust air Minimum theoretical discharge (with 100% recirculation) 3,000 m3/h Maximum theoretical discharge (with 50% recirculation) 21,000 m3/h Preliminary data to be confirmed. Actual exhaust volumes depend on conditions operational (for example coverage, degree of recirculation, maximum LEL percentage, etc.). Dehumidified compressed air 7 hPa The connection points are indicated in the general machine diagram Noise level The Sound pressure level regarding the CCS supply parts and with the ventilation attached to the machine is contained within 85dbA. Please note: All energy data listed above are to be understood as preliminary and non-binding. THE actual data will be confirmed once the actual machine configuration has been defined. Car shooting: 35-400 N UNWINDER AND WINDER: Unwinder: Maximum coil diameter: 1,000 mm Internal diameter of the core 76/152 mm Maximum reel weight: 1,250 kg Winder: Maximum coil diameter: 1,000 mm Internal diameter of the core 152 mm Maximum reel weight: 1,250 kg Belt travel direction From right to left Implant colors: Machine color White RAL 9002 Long platform band Gray RAL 9023 Button panel color Black RAL 7016 Applied legislation Electrical reference standards: EN, CENELEC, CEI Safety standards: European standards for printing and converting machines EN 1010 and regulations for installations issued by bodies recognized by the EU.